NETGEAR GSM7228PS - Page 436

436 | Chapter 27. DHCP L2 Relay and L3 Relay
ProSafe 7000 Managed Switch Release 8.0.3
f. Click Apply to save the settings.
3. Enable RIP on interface 1/0/4.
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
b. In the Interface list, select 1/0/4.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply to save the settings.
4. Create a routing interface and assign 10.200.1.1/24 to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Under IP Interface Configuration, scroll down and select the Port 1/0/15 check box.
c. In the IP Address field, enter 10.200.1.1.
d. In the Subnet Mask field, enter 255.255.255.0.
e. In the Routing Mode field, select Enable.
f. Click Apply to save the settings.
5. Redistribute the connected routes to RIP.