328 | Chapter 19. SNMP
ProSafe 7000 Managed Switch Release 8.0.3
e. In the Receiver Address field, enter 192.168.10.2. A screen similar to the following
displays.
f. Click Apply. A screen similar to the following displays.
2. Configure the sampling ports sFlow receiver index, sampling rate, and sampling maximum
header size.
a. Select Monitoring > sFlow > Advanced > sFlow Interface Configuration. A
screen similar to the following displays.
b. Select theInterface 1/0/1 check box.
c. In the Sampling Rate field, enter 1024.
d. In the Maximum Header Size field, enter 64.
e. Click Apply. A screen similar to the following displays.
To Next Page
Loading...
