102 | Chapter 7. OSPF
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > OSPFv3 > Advanced > Interface Configuration. A screen similar
to the following displays.
b. Under IP Interface Configuration, scroll down and select the interface 1/0/1 check
box. Now 1/0/1 appears in the Interface field at the top.
• In the OSPF Area ID field, enter 0.0.0.0.
• In the Admin Mode field, select Enable.
c. Click Apply to save the settings.
6. Display the OSPFv3 Neighbor Table.
a. Select Routing > OSPFv3 > Advanced > Neighbor Table. A screen similar to the
following displays.
To use the Web interface to configure OSPF on switch A2, repeat this process for switch A2.
To Next Page
Loading...
