NETGEAR GSM7228PS - Page 114

114 | Chapter 10. ACLs
ProSafe 7000 Managed Switch Release 8.0.3
2. Define the second rule for ACL 101 to set conditions for UDP traffic similar to those for TCP
traffic.
(Netgear Switch) (Config)#access-list 101 permit udp 192.168.77.0 0.0.0.255
192.178.77.0 0.0.0.255
3. Apply the rule to inbound traffic on port 1/0/2. Only traffic matching the criteria will be
accepted.
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip access-group 101 in
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit
Web Interface: Set Up an IP ACL with Two Rules
1. Create IP ACL 101 on the switch.
a. Select Security > ACL > IP ACL. A screen similar to the following displays.
b. In the IP ACL ID field, enter 101.
c. Click Add to create ACL 101.
2. Create a new rule associated with ACL 101.
a. Select Security > ACL > IP ACL > IP Extended Rules. A screen similar to the
following displays.
b. For ACL ID, select 101.