NETGEAR GSM7228PS - Page 131

Chapter 10. ACLs | 131
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > VLAN > VLAN Routing Wizard. A screen similar to the following
displays.
b. Enter the following information:
• In the Vlan ID field, enter 200.
• In the IP Address field, enter 192.168.200.2.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
d. Click the gray box under port 48 twice until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply to save VLAN 200.
4. Create a static route with IP address 192.168.100.0/24:
a. Select Routing > Routing Table > Basic > Route Configuration. A screen similar to
the following displays.
b. Under Configure Routes, make the following selections and enter the following
information:
• Select Static in the Route Type field.
• In the Network Address field, enter 192.168.100.0.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Next Hop IP Address field, enter 192.168.200.1.