Chapter 10. ACLs | 133
ProSafe 7000 Managed Switch Release 8.0.3
PC 2 are isolated by an ACL but can both access the server. The example is shown as CLI
commands and as a Web interface procedure.
Server
10.100.5.252
Port 11/0/38
10.100.5.34
Layer 3 switch
Port 1/0/24
192.148.24.1
Port 1/0/48
192.148.48.1
PC2
PC1
192.148.24.2 192.148.48.2
Figure 16. Using ACLs to isolate VLANs on a Layer 3 switch
CLI: Configure One-Way Access Using a TCP Flag in ACL
Commands
1. Enter the following CLI commands.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 24
(Netgear Switch) (Vlan)#vlan routing 24
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#vlan participation include 24
(Netgear Switch) (Interface 1/0/24)#vlan pvid 24
(Netgear Switch) (Interface 1/0/24)#exit
(Netgear Switch) (Config)#interface vlan 24
(Netgear Switch) (Interface-vlan 24)#routing
(Netgear Switch) (Interface-vlan 24)#ip address 192.168.24.1 255.255.255.0
(Netgear Switch) (Interface-vlan 24)#exit
(Netgear Switch) (Config)#exit
To Next Page
Loading...
