NETGEAR GSM7228PS - Page 137

Chapter 10. ACLs | 137
ProSafe 7000 Managed Switch Release 8.0.3
c. Click Unit 1. The ports display.
d. Click the gray box under port 48 twice until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply to save VLAN 48.
3. Create VLAN 38 with IP address 10.100.5.34.
a. Select Routing > VLAN > VLAN Routing Wizard. A screen similar to the following
displays.
b. Enter the following information in the VLAN Routing Wizard:
• In the Vlan ID field, enter 38.
• In the IP Address field, enter 10.100.5.34.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
d. Click the gray box under port 38 twice until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply to save VLAN 38.
4. Enable IP routing:
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. Under IP Configuration, make the following selections:
• For Routing Mode, select the Enable radio button.
• For IP Forwarding Mode, select the Enable radio button.