NETGEAR GSM7228PS - Page 148

148 | Chapter 10. ACLs
ProSafe 7000 Managed Switch Release 8.0.3
1. Create an IP access control list with the name monitorHost.
(Netgear Switch) (Config)# ip access-list monitorHost
2. Define the rules to match host 10.0.0.1 and to permit all others.
(Netgear Switch) (Config-ipv4-acl)# permit ip 10.0.0.1 0.0.0.0 any mirror 1/0/19
(Netgear Switch) (Config-ipv4-acl)# permit every
3. Bind the ACL with interface 1/0/1.
(Netgear Switch) (Interface 1/0/1)#ip access-group monitorHost in 1
4. View the configuration.
(Netgear Switch) # show ip access-lists
Current number of ACLs: 1 Maximum number of ACLs: 100
ACL ID/Name Rules Direction Interface(s) VLAN(s)
------------------- ----- ---------- ------------------ ---------------
monitorHost 2 inbound 1/0/1
(Netgear Switch) #show ip access-lists monitorHost
ACL Name: monitorHost
Inbound Interface(s): 1/0/1
Rule Number: 1
Action......................................... permit
Match All...................................... FALSE
Protocol....................................... 255(ip)
Source IP Address.............................. 10.0.0.1
Source IP Mask................................. 0.0.0.0
Mirror Interface............................... 1/0/19
Rule Number: 2
Action......................................... permit
Match All...................................... TRUE
Web Interface: Configure ACL Mirroring
1. Create an IP access control list with the name monitorHost on the switch.