NETGEAR GSM7228PS - Page 153

Chapter 10. ACLs | 153
ProSafe 7000 Managed Switch Release 8.0.3
1. Create an IP access control list with the name redirectHTTP.
(Netgear Switch) (Config)#ip access-list redirectHTTP
2. Define a rule to match the HTTP stream and define a rule to permit all others.
(Netgear Switch) (Config-ipv4-acl)# permit tcp any any eq http redirect 1/0/19
(Netgear Switch) (Config-ipv4-acl)# permit every
3. Bind the ACL with interface 1/0/1.
(Netgear Switch) (Interface 1/0/1)#ip access-group redirectHTTP in 1
4. View the configuration.
(Netgear Switch) # show ip access-lists
Current number of ACLs: 1 Maximum number of ACLs: 100
ACL ID/Name Rules Direction Interface(s) VLAN(s)
------------------------- ----- ---------- ------------------- ------------
redirectHTTP 2 inbound 1/0/1
(Netgear Switch) #show ip access-lists redirectHTTP
ACL Name: redirectHTTP
Inbound Interface(s): 1/0/1
Rule Number: 1
Action......................................... permit
Match All...................................... FALSE
Protocol....................................... 6(tcp)
Destination L4 Port Keyword.................... 80(www/http)
Redirect Interface............................. 1/0/19
Rule Number: 2
Action......................................... permit
Match All...................................... TRUE
Web Interface: Redirect a Traffic Stream
This example redirects the HTTP traffic stream received in port 1/0/1 to port 1/0/19.
1. Create an IP access control list with the name redirectHTTP.