246 | Chapter 14. Security Management
ProSafe 7000 Managed Switch Release 8.0.3
c. In the VLAN Type field, select Static.
d. Click Add.
2. Add ports to VLAN 2000.
a. Select Switching > VLAN > Advanced > VLAN Membership. A screen similar to the
following displays.
b. In the VLAN ID list, select 2000 .
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 1 and 24 until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply.
3. Set force authorized mode on ports 1/0/6 and 1/0/12.
a. Select Security > Port Authentication > Advanced > Port Authentication. A
screen similar to the following displays.
b. Scroll down and select the Interface 1/0/6 and 1/0/12, check boxes.
c. In the Control Mode list, select Force Authorized.
d. Click Apply to save settings.
4. Enable dot1x on the switch.
To Next Page
Loading...
