250 | Chapter 14. Security Management
ProSafe 7000 Managed Switch Release 8.0.3
2. Enable dot1x authentication on the switch
(Netgear Switch) (Config)#dot1x system-auth-control
3. Use the RADIUS as the authenticator.
(Netgear Switch) (Config)#aaa authentication dot1x default radius
4. Enable the switch to accept VLAN assignment by the RADIUS server.
(Netgear Switch) (Config)#authorization network radius
5. Set the RADIUS server IP address.
(Netgear Switch) (Config)#radius server host auth 192.168.0.1
6. Set the NAS-IP address for the RADIUS server..
(Netgear Switch) (Config)#radius server key auth 192.168.0.1
Enter secret (16 characters max):12345
Re-enter secret:12345
Set the radius server key.
(Netgear Switch) (Config)#radius server attribute 4 192.168.0.1
7. Force 1/0/6 to be authorized for it to connect to the RADIUS server.
(Netgear Switch) (Config)#interface 1/0/6
(Netgear Switch) (Interface 1/0/6)#dot1x port-control force-authorized
(Netgear Switch) (Interface 1/0/6)#exit
To Next Page
Loading...
