Chapter 14. Security Management | 261
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Configure Static Mapping
1. Create an ARP ACL.
a. Select Security > Control > Dynamic ARP Inspection > DAI ACL Configuration.
b. In the Name field, enter ArpFilter.
c. Click Add. A screen similar to the following displays.
2. Configure a rule to allow the static client.
a. Select Security > Control > Dynamic ARP Inspection > DAI ACL Rule
Configuration.
b. In the ACL Name list, select ArpFilter.
c. In the Source IP Address field, enter 192.168.10.2.
d. In the Source MAC Address field, enter 00:11:85:EE:54:E9.
e. Click Add. A screen similar to the following displays.
3. Configure the ARP ACL used for VLAN 1.
a. Select Security > Control > Dynamic ARP Inspection > DAI VLAN Configuration.
b. In the ARP ACL Name field, enter ArpFilter.
To Next Page
Loading...
