NETGEAR GSM7228PS - Page 309

Chapter 18. Switch Stacks | 309
ProSafe 7000 Managed Switch Release 8.0.3
CLI: Configure a Stacking Port as an Ethernet Port
1. On Switch A, Configure the Stack Port and Reboot
(Netgear Switch) #show stack-port
Configured Running Link
Stack Stack Link Speed
Unit Intf SlotId Type XFP Adapter Mode Mode Status (Gb/s)
---- ----- ------ ------ ----------- ------- ------ ----- -----
2 0/27 None Stack Stack Link Down 0
2 0/28 AX742 (stack) Stack Stack Link Down 12
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 ethernet
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #reload
Are you sure you want to reload the stack? (y/n) y
(Netgear Switch) #show port 2/0/28
Admin Physical Physical Link Link LACP Actor
Intf Type Mode Mode Status Status Trap Mode Timeout
------ ----- ------- -------- --------- ------ ------- ------- ------
2/0/28 Enable 10G Full 10G Full Up Enable Enable long
After Switch A reboots:
2. On Switch B, Configure the stack port and reboot
(Netgear Switch) #
(Netgear Switch) #show stack-port
Configured Running Link
Stack Stack Link Speed
Unit Intf SlotId Type XFP Adapter Mode Mode Status (Gb/s)
---- ----- ------ ------ ----------- ------- ------ ----- -----
1 0/51 AX742 (stack) Ethernet Ethernet Link Down 12
1 0/52 AX741 Ethernet Ethernet Link Down 10
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 1/0/51 ethernet
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #reload
Are you sure you want to reload the stack? (y/n) y
.