Chapter 18. Switch Stacks | 313
ProSafe 7000 Managed Switch Release 8.0.3
On Switch A, you see the following:
(Netgear Switch) #show switch
Management Standby Preconfig Plugged-in Switch Code
SW Switch Status Model ID Model ID Status Version
--- ---------- -------- ----------- ----------- --------- -----------
1 Mgmt Sw GSM7352Sv2 GSM7352Sv2 OK 8.0.1.2
2 Stack Mbr Oper Stby GSM7328Sv2 GSM7328Sv2 OK 8.0.1.2
Web Interface: Stack Switches Using 10G Fiber
1. On Switch A, show the Port Information.
a. Select System > Stacking > Advanced > Stack Port Configuration. A screen
similar to the following displays.
b. Since the port 1/0/52 is stack mode already, nothing needs to be done.
2. On Switch B, configure port 2/0/28 as stacking port.
a. Select System > Stacking > Advanced > Stack Port Configuration. A screen
similar to the following displays.
b. Scroll down and select the 2/0/28 check box.
c. In the Configured Stack Mode list, select Stack.
d. Click Apply to save the settings.
3. Reboot the switch.
To Next Page
Loading...
