Chapter 18. Switch Stacks | 319
ProSafe 7000 Managed Switch Release 8.0.3
• If you need to reassign multiple existing stack unit numbers, the configuration could
become mismatched. To avoid this situation, NETGEAR recommends that you power
down all switches except the master, and then add them back one at a time using the
procedure in Section Add Switches to an Operating Stack on page 314.
Web Interface: Renumber Stack Members
1. Renumber the stacking member’s ID from 3 to 2.
a. Select System > Management > Basic > Stack Configuration. A screen similar to
the following displays.
b. Under Stack Configuration, scroll down and select the Unit ID 3 check box.
c. In the Unit ID list, select 2.
d. Click Apply.
e. Now the unit ID of the stacking member is 2.
To Next Page
Loading...
