Chapter 21. DHCP Server | 335
ProSafe 7000 Managed Switch Release 8.0.3
d. Click the gray boxes under ports 1 and 24 until U displays. The U specifies that the
egress packet is untagged for the port.
e. Click Apply.
3. Assign PVID to the VLAN 200.
a. Select Switching > VLAN> Advanced > Port PVID Configuration. A screen similar
to the following displays.
b. Under Port PVID Configuration, scroll down and select the 1/0/1 check box.
c. In the PVID (1 to 4093) field, enter 200.
d. Click Apply to save the settings.
4. Create a new DHCP pool.
a. Select System > Services > DHCP Server > DHCP Server Configuration. A screen
similar to the following displays.
b. For Admin Mode, select the Enable radio button.
c. Click Apply to enable the DHCP service.
To Next Page
Loading...
