NETGEAR GSM7228PS - Page 340

340 | Chapter 22. Double VLANs and Private VLAN Groups
ProSafe 7000 Managed Switch Release 8.0.3
The following example shows how to configure the NETGEAR switch shown in the preceding
figure to add a double VLAN tag for traffic going from the subnet domain connected to port
1/0/24. This example assumes there is a Layer 2 switch connecting all these devices in your
domain. The Layer 2 switch tags the packet going to the NETGEAR switch port 1/0/24. The
example is shown as CLI commands and as a Web interface procedure.
CLI: Enable a Double VLAN
Create a VLAN 200.
(Netgear Switch)#vlan database
(Netgear Switch) (Vlan)#vlan 200
(Netgear Switch) (Vlan)#exit
Add interface 1/0/24 to VLAN 200, add pvid 200 to port.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#vlan pvid 200
(Netgear Switch) (Interface 1/0/24)#vlan participation include 200
(Netgear Switch) (Interface 1/0/24)#exit
Add interface 1/0/48 to the VLAN 200 in a tagging mode.
(Netgear Switch) (Config)#interface 1/0/48
(Netgear Switch) (Interface 1/0/48)#vlan participation include 200
(Netgear Switch) (Interface 1/0/48)#vlan tagging 200
(Netgear Switch) (Interface 1/0/48)#exit
Select interface 1/0/48 as the provider port.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#interface 1/0/48
(Netgear Switch) (Interface 1/0/48)#mode dvlan-tunnel
(Netgear Switch) (Interface 1/0/48)#exit
Web Interface: Enable a Double VLAN
1. Create static VLAN 200: