NETGEAR GSM7228PS - Page 37

Chapter 3. LAG s | 37
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Add Ports to LAGs
1. Add ports to lag_10.
a. Select Switching > LAG > LAG Membership. A screen similar to the following
displays.
b. In the LAG ID list, select LAG 1.
c. Click Unit 1. The ports display.
d. Click the gray boxes under port 2 and 3. Two check marks display in the box.
e. Click Apply to save the settings.
2. Add ports to lag_20.
a. Select Switching > LAG > LAG Membership. A screen similar to the following
displays.
b. Under LAG Membership, in the LAG ID list, select LAG 2.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 8 and 9. Two check marks display in the boxes.
e. Click Apply to save the settings.