372 | Chapter 25. IPv6 Interface Configuration
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > IPv6 > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Click VLANS. The logical VLAN interface 0/4/2 displays.
c. Select the 0/4/2 check box.
d. Under IPv6 Interface Configuration, in the IPv6 Mode field, select Enable.
e. Click Apply.
6. Assign an IPv6 address to the routing VLAN.
a. Select Routing > IPv6 > Advanced > Prefix Configuration. A screen similar to the
following displays.
b. In the Interface field, select 0/4/2.
c. In the IPv6 Prefix field, enter 2000::1.
d. In the Length field, enter 64.
e. In the EUI64 field, select Disable.
f. Click Add.
To Next Page
Loading...
