Chapter 26. PIM | 379
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Configure PIM-DM
PIM-DM on Switch A
1. Enable IP routing on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Configure 1/0/1 as a routing port and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Under IP Interface Configuration, scroll down and select the Port 1/0/1 check box.
Now 1/0/1 appears in the Port field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.2.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
3. Configure 1/0/9 as a routing port and assign an IP address to it.
To Next Page
Loading...
