NETGEAR GSM7228PS - Page 404

404 | Chapter 26. PIM
ProSafe 7000 Managed Switch Release 8.0.3
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
5. Enable RIP on interface 1/0/1.
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
b. In the Interface field, select 1/0/1.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply.
6. Enable RIP on interface 1/0/9.
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
b. In the Interface field, select 1/0/9.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply.
7. Enable RIP on interface 1/0/13.