Chapter 26. PIM | 413
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the 1/0/22 check box. Now 1/0/22 appears in the Interface
field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.6.1.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
4. Enable RIP on the interface 1/0/21.
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
b. In the Interface field, select 1/0/21.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply.
5. Enable RIP on interface 1/0/22.
To Next Page
Loading...
