NETGEAR GSM7228PS - Page 426

426 | Chapter 27. DHCP L2 Relay and L3 Relay
ProSafe 7000 Managed Switch Release 8.0.3
6. Enable DHCP L2 relay on port 1/0/5.
(Netgear Switch) (Config)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)# dhcp l2relay
(Netgear Switch) (Interface 1/0/5)# vlan pvid 200
(Netgear Switch) (Interface 1/0/5)# vlan participation include 200
(Netgear Switch) (Interface 1/0/5)# exit
7. Enable DHCP L2 relay on port 1/0/6.
(Netgear Switch) (Config)#interface 1/0/6
(Netgear Switch) (Interface 1/0/6)# dhcp l2relay
8. Trust packets with option 82 received on port 1/0/6.
(Netgear Switch) (Interface 1/0/6)# dhcp l2relay trust
(Netgear Switch) (Interface 1/0/6)# vlan pvid 200
(Netgear Switch) (Interface 1/0/6)# vlan participation include 200
(Netgear Switch) (Interface 1/0/6)# exit
Web Interface: Enable DHCP L2 Relay
1. Create VLAN 200.
a. Select Switching > VLAN > Basic > VLAN Configuration. A screen similar to the
following displays.
b. In the VLAN ID field, enter 200.
c. In the VLAN Type field, select Static.
d. Click Add.
2. Add ports to VLAN 200.