432 | Chapter 27. DHCP L2 Relay and L3 Relay
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the 1/0/3 check box.
c. In the IP Address field, enter 10.100.1.1.
d. In the Subnet Mask field, enter 255.255.255.0.
e. In the Routing Mode field, select Enable.
f. Click Apply to save the settings.
3. Enable RIP on interface 1/0/3.
a. Select Routing > RIP >Advanced > Interface Configuration. A screen similar to the
following displays.
b. In the Interface field, select 1/0/3.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply to save the settings.
4. Set up the DHCP global configuration.
To Next Page
Loading...
