NETGEAR GSM7228PS - Page 441

Chapter 28. MLD | 441
ProSafe 7000 Managed Switch Release 8.0.3
5. Enable IP multicast forwarding on the switch.
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#ip multicast
6. Enable MLD on interface 1/0/24.
(Netgear Switch) (Config)#interface 1/0/21
(Netgear Switch) (Interface 1/0/21)#routing
(Netgear Switch) (Interface 1/0/21)#ipv6 address 2001:1::2/64
(Netgear Switch) (Interface 1/0/21)#ipv6 enable
(Netgear Switch) (Interface 1/0/21)#ipv6 pimdm
(Netgear Switch) (Interface 1/0/21)#ipv6 ospf
(Netgear Switch) (Interface 1/0/21)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#routing
(Netgear Switch) (Interface 1/0/24)#ipv6 address 2001:3::1/64
(Netgear Switch) (Interface 1/0/24)#ipv6 enable
(Netgear Switch) (Interface 1/0/24)#ipv6 mld router
(Netgear Switch) (Interface 1/0/24)#ipv6 pimdm
(Netgear Switch) (Interface 1/0/24)#exit
The MLD group information on switch B:
(B) #show ipv6 mld groups ff32::1
Interface...................................... 71/1/24
Group Address.................................. FF32::1
Last Reporter.................................. FE80::200:4FF:FEE8:5EFC
Up Time (hh:mm:ss)............................. 00:00:18
Expiry Time (hh:mm:ss)......................... ------
Filter Mode.................................... Include
Version1 Host Timer............................ ------
Group compat mode.............................. v2
Source Address ExpiryTime
----------------- -----------
2001:2::2 00:04:02
Web Interface: Configure MLD
MLD on Switch A
1. Enable IP routing on the switch.