46 | Chapter 4. Port Routing
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Add a Static Route
1. Select Routing > Routing Table > Basic > Route Configuration to display the Route
Configuration screen.
2. In the Route Type list, select Static.
3. Fill in the Network Address field. Note that this field ishould have a network IP address, not
a host IP address. Do not enter something like 10,100.100.1. The last number should
always be 0 (zero).
4. In the Subnet Mask field, enter a value that matches the subnet range that you want to use.
5. The Preference field is optional. A value of 1 is entered by default if you do not enter a
number.
6. Click the Add button on the bottom of the screen. The screen is updated with the static route
shown in the routing table.
7. To remove a route entry, either static or default, select the check box to the left of the entry,
and click the Delete button on the bottom of the screen.
To Next Page
Loading...
