NETGEAR GSM7228PS - Page 462

462 | Chapter 29. DVMRP
ProSafe 7000 Managed Switch Release 8.0.3
DVRMP on Switch C:
1. Create routing interfaceS 1/0/11, 1/0/3, and 1/0/24.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#ip interface 1/0/11
(Netgear Switch) (Interface 1/0/11)#ip routing
(Netgear Switch) (Interface 1/0/11)#ip address 192.168.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/11)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.168.4.2 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#routing
(Netgear Switch) (Interface 1/0/24)#ip address 192.168.5.1 255.255.255.0
(Netgear Switch) (Interface 1/0/24)#exit
2. Enable IP multicast forwarding on the switch.
(Netgear Switch) (Config)#ip multicast
3. Enable IP DVMRP protocol on the switch.
(Netgear Switch) (Config) #ip dvmrp
4.
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#ip dvmrp
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#interface 1/0/11
(Netgear Switch) (Interface 1/0/11)#ip dvmrp
(Netgear Switch) (Interface 1/0/11)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#ip dvrmp
(Netgear Switch) (Interface 1/0/24)#exit
Enable DVMRP mode on interfaces 1/0/3, 1/0/11, and 1/0/24.
5. Enable IGMP protocol on the switch.
(Netgear Switch) (Config)# ip igmp