NETGEAR GSM7228PS - Page 79

Chapter 7. OSPF | 79
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Under Interface Configuration, scroll down and select the interface 2/0/11 check box.
Now 2/0/11 appears in the Interface field at the top.
• In the OSPF Area ID field, enter 0.0.0.0.
• In the the Admin Mode field, select Enable.
c. Click Apply to save the settings.
6. Enable OSPF on the port 2/0/19.
a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Under Interface Configuration, scroll down and select the interface 2/0/19 check box.
Now 2/0/19 appears in the Interface field at the top.
• In the OSPF Area ID field, enter 0.0.0.1.
• In the the OSPF Admin Mode field, select Enable.
c. Click Apply to save the settings.
7. Configure area 0.0.0.1 as a stub area.