Chapter 7. OSPF | 83
ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Under Interface Configuration, scroll down and select the interface 1/0/15 check box.
Now 1/0/15 appears in the Interface field at the top.
• In the OSPF Area ID field, enter 0.0.0.1.
• In the OSPF Admin Mode field, select Enable.
c. Click Apply to save the settings.
5. Configure area 0.0.0.1 as a stub area.
a. Select Routing > OSPF > Advanced > Stub Area Configuration. A screen similar
to the following displays.
b. In the Area ID field, enter 0.0.0.1.
c. Click Add to save the settings.
To Next Page
Loading...
