90 | Chapter 7. OSPF
ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Configure Area 1 as an nssa Area on A2
1. Enable IP routing on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Assign IP address 192.168.30.1 to port 1/0/11.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the interface 1/0/11 check box. Now 1/0/11 appears in the
Interface field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.30.1.
• In the Network Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
3. Assign IP address 192.168.20.2 to port 1/0/15.
To Next Page
Loading...
