92 | Chapter 7. OSPF
ProSafe 7000 Managed Switch Release 8.0.3
b. Enter the following information:
• In the Interface field, select 1/0/11.
• For RIP Admin Mode, select the Enable radio button.
c. Click Apply to save the settings.
6. Enable OSPF on port 1/0/15.
a. Select Routing > OSPF > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the interface 1/0/15 check box. Now 1/0/15 appears in the
Interface field at the top.
c. Enter the following information:
• In the OSPF Area ID field, enter 0.0.0.1.
• In the OSPF Admin Mode field, select Enable.
d. Click Apply to save the settings.
7. Configure area 0.0.0.1 as an nssa area.
a. Select Routing > OSPF > Advanced > NSSA Area Configuration. A screen similar
to the following displays.
b. In the Area ID field, enter 0.0.0.1.
c. Click Add to save the settings.
8. Redistribute the RIP routes into the OSPF area.
To Next Page
Loading...
