96 | Chapter 7. OSPF
ProSafe 7000 Managed Switch Release 8.0.3
Click the gray box under port 2 until T displays. The T specifies that the egress packet
is tagged for the port.
d. Click Apply to save the VLAN that includes ports 2.
2. Configure a VLAN, and include port 1/0/3 in the VLAN.
a. Select Routing > VLAN > VLAN Routing Wizard. A screen similar to the following
displays.
b. Enter the following information:
• In the Vlan ID field, enter 20.
• In the IP Address field, enter 192.150.4.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display:
Click the gray box under port 3 until T displays. The T specifies that the egress packet
is tagged for the port.
d. Click Apply to save the VLAN that includes port 3.
3. Enable OSPF on the switch.
a. Select Routing > OSPF > Basic > OSPF Configuration. A screen similar to the
following displays.
b. For OSPF Admin Mode, select the Enable radio button.
c. In the Router ID field, enter 192.150.9.9.
d. Click Apply to save the setting.
4. Enable OSPF on VLAN 10.
To Next Page
Loading...
