MX Series Voice Gateway User Manual
New Rock Technologies, Inc. 21
Registration has not started.
A WAN connection is established without any service flow.
A WAN connection is established with service flow.
WAN interface is disconnected.
A link is connected without any service flow.
A service flow is being transmitted.
VOICE
(Green-FXS,
yellow-FXO)
Indicates line type and device status:
The device is starting and the port is an FXO port.
The device is starting and the port is an FXS port.
No line is detected. Possibly the voice interface card is not inserted or
the port is damaged.
Indicates running status:
Calling in or out via an analog trunk.
Ringing of calling in for an analog trunk.
Off-hook or call established
The port is in idle status
Note: The device starts up for approximate 30s to indicate line type, then indicates running
status.
To restore the MX8A to factory default, press the RST for more than 3 seconds and release it
when the STU light starts blinking in red. This setting will be valid after rebooting the device.
1.3.3 MX60
Designed with a 1U high and 19-inch wide compact chassis, MX60 is suitable for installation in a standard
cabinet. MX60 has a built-in power module with the rating voltage of 100-240 V AC or -48 V DC (DC is
optional). The interface card of MX60 uses a RJ-45 socket and is connected to the distribution panel in
equipment room using CAT-5 cables supplied with the unit. MX60 offers up to 48 interfaces of FXS/FXO.
MX60 supports the following types of configuration.
Table 1-11 Configuration Combination of MX60
To Next Page
Loading...
Need help?
General
