New Rock Technologies MX series User Manual

MX Series Voice Gateway User Manual
New Rock Technologies, Inc. 91
Name
Description
SSH
Enable SSH
If this parameter is selected, terminals are allowed to access the device through SSH. It is not
selected by default.
When accessing the device through SSH, you should login with user operator, and use su root
command to change to user root.
Please disable SSH in time after accessing is finished.
SSH port
Set the SSH port for the device. The default value is 22.
Change SSH
password
Set password of user root or operator. Password must meet the following requirements:
 6 to 20 characters
 At least the two of following: English letters, numbers, and symbols
 Excluding & = “
Ping
Inbound Ping request
Block or unblock the Ping requests. The device block the ping requests by default.
2.7.2 Access list
Access list is used to specify the source addresses which are allowed to access the device through Web GUI
(HTTP/HTTPS) or SSH.
After login, click Security>Access list to open the configuration interface.
Once access list is enabled, only addresses specified here are allowed to access the device through Web GUI
or SSH.
Figure 2-56 Access list configuration Interface

New Rock Technologies MX series Specifications

General

Brand	New Rock Technologies
Model	MX series
Category	Gateway
Language	English