User Manual MX Series Voice Gateway
30 New Rock Technologies, Inc.
operator during equipment startup, diagnosis or operation. In this mode, LED flashes to display numbers,
letters or other patterns in matrix. Please refer to Table 1-29.
Figure 1-15 MX120G Back Panel-AC
Figure 1-16 MX120G Back Panel-DC
Table 1-27 MX120G Back Panel
To restore the device to factory default, press the RST for more than 3 seconds and release it
when the STU light starts blinking in red. This setting will be valid after rebooting the device.
Configuration interface (CON), used for local management and debugging.
Two 10/100 Mbps Ethernet ports (RJ45). They share one IP address, which by default is
192.168.2.240 and you can change it on Basic > Network page.
AC power socket, 100-240 VAC voltage input.
DC power socket,-48 VDC input.
To Next Page
Loading...
Need help?
General
