User Manual MX Series Voice Gateway
52 New Rock Technologies, Inc.
2.3 Line
2.3.1 Phone Number
The content below is only applicable to gateways with FXS ports.
After login, click Line > Batch Configuration (Phone number) to open the configuration interface.
Figure 2-32 Configuration Interface for Batch Configuration (Phone Number)
Table 2-13 Configuration Parameters of Batch Configuration (Phone Number)
This number is used for the batch setup of subscriber line.
Click Batch after filling in initial number, the number of Line 1 adopts initial number; that of
Line 2 increases 1 progressively based on that of Line 1, and so on.
Fill in the telephone number associated with the subscriber line n (FXS port). This should be
manually performed if Batch mode is not used.
2.3.2 Subscriber Line Features
The content below is only applicable to gateways with FXS ports.
After login, click Line > Configuration to open the configuration interface.
To Next Page
Loading...
Need help?
General
