7 To reinstall, reverse above steps 2 through 6.
Note: If the analog board PCB2104A is replaced, the e360
ventilator will need D5 calibration performed. Refer to Section 5
for the D5 calibration.
Removal and Replacement of Heater Assembly HTR2100A
Figure 4-22 Heater
Assembly HTR2100A
Refer to figure 4-22 and perform these steps:
1 Perform above steps for removal of Front Panel Assembly
DSP2102A
2 Remove 2 screws securing the door DOR2112M to the e360
ventilator
.
3 Remove 2 screws securing heater HTR2100A
to the
MNF2110A (Exhalation Manifold).
4 Remove heater cables from power supply board PCB2101A
connectors J107 and J108.
5 Remove the heater HTR2100A.
6 To reinstall, reverse above steps 2 through 5
COMPONENT REMOVAL & REPLACEMENT
Remove 2 screws and washers Heater HTR1200A
4-22 SER360 A1106
To Next Page
Loading...
