7.1 Specification
7-13 ZM2376
Other measurement related functions
• Zero correction OPEN correction and SHORT correction provided. Both can be turned on or
off.
• LOAD correction Provided. It can be turned on or off.
• Cable length correction 0m / 1m / 2m / 4m
• Contact check Provided.
Based on detection of an abnormally low capacitance or abnormal
voltage/current.
• Averaging 1 to 256 times
• Deviation measurement Primary parameters: Deviation and deviation % from reference value can be
displayed.
Secondary parameters: Deviation and deviation % from reference value can be
displayed.
• Comparator Primary parameters: Max. 14 bins
Original measured value / Deviation / Deviation % can
be sorted.
Secondary parameters: Upper limit and lower limit comparison
Original measured value / Deviation / Deviation % can
be sorted.
Beeper: Sounds according to comparison result
(Pass / Fail / Off)
• Handler interface Signal isolation: All I/O signals are optically isolated
(withstand voltage ±42V)
Input signal: Trigger, Key lock, Settings/correction value memory
designation.
High speed recalling with only spot correction value is
possible.
Output signal: Comparison result BIN1 to BIN11, NC / BIN12, PHI /
BIN13, PLO / BIN14, OUT OF BINS, S-NG, ERR,
INDEX, EOM (when BIN10 - BIN14 are used, NC,
PHI, and PLO cannot be used).
Rated power voltage: External +5V to +24V, Internal +5V (non-isolated)
• Multi-measurement Execute measurement and limit comparison under multiple conditions for
the total comparison.
Maximum number of steps: 32
Selectable measurement conditions: Measurement frequency, measurement
signal level, internal DC bias voltage, measurement parameters, etc.
To Next Page
Loading...
