NGTeco Time Clock - K4 Model User Manual
Page | 38 Copyright©2021 NGTeco. All rights reserved.
3. Press Add Wi-Fi Network to add the Wi-Fi manually.
4. On this interface, enter the Wi-Fi network parameters. (The added network must exist.)
After successfully adding the Wi-Fi manually, follow the same process to search for the
added Wi-Fi name. Click here
to view the process to search the Wi-Fi network.
6.2.3 Enable/Disable DHCP
To enable/disable DHCP, perform the following steps:
1. Go to [Comm.] then [Wireless Network].
2. Press [Advanced] to view the DHCP settings.
3. Turn on DHCP if unable to connect to WI-FI.
Figure 6-8: DHCP Interface
4. If you disable DHCP, you must manually set the IP Address, Subnet mask, and Gateway
by pressing <>. The interface is shown below:
To Next Page
Loading...
