NGTeco Time Clock - K4 Model User Manual
Page | 60 Copyright©2021 NGTeco. All rights reserved.
Figure 10-1: Attendance Rule
3. Enter the following details:
Maximum Work Hours: Set the maximum number of working hours in a day. When the
time difference between two attendance punches (check-in and check-out) exceeds this
maximum work hour, then the attendance will be calculated separately for that day. Then
you can identify that there are missing attendance punches between the actual punches
made by the users. The default value is 12 hours.
Day Cutoff Time: Set the time on which the day is changed to the next day on the clock.
Example: Consider the day change time is set to 2:00 AM. If the users start to work before
2:00 AM, then the total worked hours until check-out will be added to the previous day. If the
users start to work after 2:00 AM, then the total worked hours until check-out will be added
to the next day.
Duplicate Punch Interval: The Duplicate Punch interval defines the time duration in which
the clock considers only the first attendance punch, even if you make many attendance
punches within the defined period. The unit is minutes.
Example: Assume that the duplicate punch period is 5 minutes. If you make several check-in
attendance punches within 5 minutes, the clock considers only the first punch time and
ignores the rest of the attendance punches.
To Next Page
Loading...
