Safety
information
Introduction
Product
Information
System
design
Mechanical
Installation
Electrical
Installation
Getting
started
Optimization Parameters
Technical
data
Component
sizing
Diagnostics
UL
Information
Unidrive M Regen Design Guide 109
Issue Number: 4
Figure 6-4 Unidrive M size 6 power connections
* It is possible to connect the DC bus of a number of drives using a busbar kit (part number: 3470-0063), where DC bus fusing is not required.
See section 6.1.2 Ground connections on page 115.
L2L1 L3 U V WPE
BRDC - DC +
AC supply connections
DC connections*
(High current DC to motoring drive/s)
L1, L2, L3
(Refer to Chapter 4
)System design
Vac supply
Regen drive
L2L1 L3 U V WPE
BRDC - DC +
Motor connections
Motoring drive
Motor
Optional ground
connection
6
6
CAUTION
The internal EMC filter must be removed
from all drives in the regen system
(motoring and regen).
To Next Page
Loading...
