User Manual N11
Operation
Industrial PC
www.noax.comPage 68 of 120 3085-US-2.4
10.7
Factory default settings for operation elements
10.7.1 Device types C12, C15, C19, C21W, S15‐G2, S19
Switching the Industrial PC
on
" Press the [On/Off] key for a minimum of 1 second
" Use the “Touch Power On” function (see Chapter 10.9)
Switching the Industrial PC
off
" Press the [On/Off] key for a minimum of 6 seconds
(until IPC turns off)
Setting the display
brightness
" Change the brightness by one level: Quickly press the [+] or
[-] key
" Change the brightness continuously: Press the [+] or [-]
key and hold it down
Switching the display
on / off
" Quickly press the [On/Off] key
Shutting the software
down
" Press the [On/Off] key and hold it down (an intermittent beep
will be heard and the power LED will flash). Release after
3 seconds (when a fast, intermittent beep can be heard and
the power LED flashes faster)
This function is only available on operating systems with
ACPI support.
" Press the [On/Off] and [-] keys together for more
than 3 seconds
Starting with default setup
(= default factory settings)
" Press and hold both the [F] or [F1] and [+] keys together,
and then
connect the power supply.
(OK LED flashes) The Industrial PC starts up with the default
factory settings (default setup)
Switching touch cleaning
mode on/off
(deactivating touchscreen)
" Press the [F] or [F1] and [+] and [-] keys together for more
than 1 second (INPUT LED flashes).
For more information on this see Chapters 13 and 11.8.
[F] key for device types S15‐G2 and S19
[F1] key for device types C12, C15, C19, and C21W
Legend for LEDs: Power LED (blue), OK LED (green), Input LED (yellow)
When starting with default setup (OK LED flashes), the settings chosen by the user are
not lost. The nSMART™ software can be used to change and save the settings.
If the Industrial PC is then restarted (without the key combination), the settings defined
and saved by the user will be reloaded.
To Next Page
Loading...