noax N11 - Default Settings for C12 P, C15 P, S15 P, S19 P, S21 WP

User Manual N11
Operation
Industrial PC
www.noax.comPage 70 of 120 3085-US-2.4
10.7.4
Device type C12P, C15P, S15P, S19P, S21WP
Function
Default factory setting
Switching the Industrial PC
on
" Press the [On/Off] key for a minimum of 1 second
Switching the Industrial PC
off
" Press the [On/Off] key for a minimum of 6 seconds
(until IPC turns off)
Setting the display
brightness
" Change the brightness by one level: Quickly press the [+] or
[-] key
" Change the brightness continuously: Press the [+] or [-]
key and hold it down
Switching the display
on/off
" Quickly press the [On/Off] key
Shutting the software
down
" Press the [On/Off] key and hold it down (an intermittent beep
will be heard and the power LED will flash). Release after
3 seconds (when a fast, intermittent beep can be heard and
the power LED flashes faster)
This function is only available on operating systems with
ACPI support.
Resetting the mainboard
" Press the [On/Off] and [-] keys together for more
than 3 seconds
Switching touch cleaning
mode on/off
(deactivating touchscreen)
" Press the [F1] and [+] and [-] keys together for more than
1 second (INPUT LED flashes).
For more information on this, see Chapters 13 and 11.8
.
Legend for LEDs: Power LED (blue), OK LED (green), Input LED (yellow)