noax N11 - Default Settings for S15 R, S19 R, S21 WR

User Manual N11
Operation
Industrial PC
3085-US-2.4 www.noax.com Page 71 of 120
10.7.5 Device type S15R, S19R, S21WR
Function
Default factory setting
Switching the Industrial PC
on
" Press the [On/Off] key for a minimum of 1 second
Switching the Industrial PC
off
" Press the [On/Off] key for a minimum of 6 seconds
(until IPC turns off)
Setting the display
brightness
" Change the brightness by one level: Quickly press the [+] or
[-] key
" Change the brightness continuously: Press the [+] or [-]
key and hold it down
Switching the display
on/off
" Quickly press the [On/Off] key
Shutting the software
down
" Press the [On/Off] key and hold it down (an intermittent beep
will be heard and the power LED will flash). Release after
3 seconds (when a fast, intermittent beep can be heard and
the power LED flashes faster)
This function is only available on operating systems with
ACPI support.
Resetting the mainboard
" Press the [On/Off] key and hold it down,
then press the [-] key and hold down the keys
together for more than 3 seconds
Switching touch cleaning
mode on/off
(deactivating touchscreen)
" Press the [F1] key and hold it down, then press the [+] key
and hold down the keys together for longer than 1 second
(INPUT LED flashes).
For more information on this, see Chapters 13 and 11.8.
Legend for LEDs: Power LED (blue), OK LED (green), Input LED (yellow)