User Manual N11
Operation
Industrial PC
www.noax.comPage 72 of 120 3085-US-2.4
10.8
Automatically reducing the screen brightness
This function is not available on devices with a PCAP touchscreen.
In the default factory settings, the display brightness is dimmed to a preset lower
brightness level 3 minutes after a key or the touchscreen is last pressed.
Reducing the display
brightness
" 3 minutes after a key or the touchscreen is last pressed
" Press the [On/Off] key or the [ON‐OFF I] key
" Press the touchscreen
10.9 “Touch Power On” function
This function is not available on devices with a PCAP touchscreen.
The “Touch Power On” function allows users to switch on the Industrial PC by pressing
two specific points on the touchscreen surface.
Two definable touch points must be pressed and held in the right sequence and within
a certain time.
This function was developed especially for devices which do not have a control panel.
See Chapter 11.6 on calibrating the touch points for “Touch Power On”.
10.10 Calibrating the touchscreen
Calibration is not necessary on devices with a PCAP touchscreen.
The calibration of the touchscreen only needs to be done if the touch point on the
touchscreen and the trigger point on the displayed user interface differ too much.
The calibration tool can be accessed directly from the nSMART™ software.
See Chapter 11.7 on calibrating the touchscreen.
The PCAP touchscreen is calibrated automatically in line with the ambient conditions
and so does not need to be calibrated manually.
To Next Page
Loading...