MPLS and RSVP-TE
232
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
3.24.2.2.4 Message Pacing Commands
msg-pacing
Syntax [no] msg-pacing
Context config>router>rsvp
Description This command enables RSVP-TE message pacing, which is defined by the max-burst and
period commands. A count is kept of the messages that were dropped because the output
queue for the interface used for message pacing was full.
Default no msg-pacing
max-burst
Syntax max-burst number
no max-burst
Context config>router>rsvp>msg-pacing
Description This command specifies the maximum number of RSVP-TE messages that can be sent
under normal operating conditions, as specified by the period command. The no form of this
command reverts to the default value.
Default 650
Parameters number — maximum number of RSVP-TE messages
Values 100 to 1000, in increments of 10
period
Syntax period milli-seconds
no period
Context config>router>rsvp>msg-pacing
Description This command specifies the time interval, in milliseconds, during which the router can send
RSVP-TE messages, as specified by the max-burst command. The no form of this
command reverts to the default value.
Default 100
Parameters milli-seconds — the time interval during which the router can send RSVP-TE messages
Values 100 to 1000 milliseconds, in increments of 10 milliseconds
To Next Page
Loading...
