MPLS Guide Label Distribution Protocol
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
477
Description This command enables or disables IPv6 prefix FEC capability on the session or interface.
Default prefix-ipv6 disable
Parameters enable | disable — enables or disables IPv6 prefix FEC capability
tcp-session-parameters
Syntax tcp-session-parameters
Context config>router>ldp
Description This command enables the context to configure parameters for the TCP transport session of
an LDP session to a remote peer.
Default n/a
peer-transport
Syntax [no] peer-transport ip-address
Context config>router>ldp>tcp-session-parameters
Description This command configures the peer transport address, which is the IPv4 or IPv6 destination
address of the TCP connection to the LDP peer.
Default n/a
Parameters ip-address — the IPv4 or IPv6 address of the TCP connection to the LDP peer in dotted
decimal notation
auth-keychain
Syntax auth-keychain name
no auth-keychain
Context config>router>ldp>tcp-session-params>peer-transport
Description This command associates an authentication keychain with LDP. The keychain is a collection
of keys used to authenticate LDP messages from remote peers. The keychain allows the
rollover of authentication keys during the lifetime of a session and also supports stronger
authentication algorithms than clear text and MD5.
The keychain must already be defined in the config>system>security>keychain context.
To Next Page
Loading...
