Nordson iControl Series - Normal Default Move Example; Part at Lead Example; Part in Front of Guns Example

Ethernet and Gun Mover Configuration
4-15
Part 1056418-07
E 2019 Nordson Corporation
Normal Default Move Example
For this example, the default move settings are:
Gun-to-Part Distance = 10, Lead = 4, Lag = 4
1. Part at Lead: When the leading edge of the part is 4 inches from the
guns (Lead), the positioner moves the guns to 10 inches from the part
(Figure 4-7).
8 in.
Conveyor Centerline
Lead: 4 in.
Default Gun-to-Part
Wait Position
Figure 4-7 Part at Lead: Move Back Until Guns are 10 in. From Part (Top View)
2. Part in front of guns: The positioner follows the contours of the part as
the part moves by the spray guns, maintaining the 10-inch gun to part
distance (Figure 4-8).
Conveyor Centerline
Default Gun-to-Part
Figure 4-8 Part in Front of Guns: Gun-to-Part Distance Maintained (Top View)