To Next Page

To Previous Page

PAGE 36 1010/2020 INSTALLATION AND PROGRAMMING MANUAL

PARTIAL SYSTEM PROGRAMMING

Option 1 from the Main Programming menu allows the programmer to change the programming of

system-wide functions such as Alarm Verification of detectors, enabling Rapid Polling, and enabling

supervision of peripheral equipment in the system, Additional system parameters, such as the

number of Loops, Annunciators and ISIB in the system. Loops can also be changed in Partial

System Programming.

After selecting option 1 from the Main Programming menu, the display will show the Partial System

Programming submenu:

PRESS.1=INST, 2=STY, 3=TDLY, 4=AVPS, 5=ZBND, 6=EXTEQ, 7=LOCP, 8=ISIB, 9=PARM...

The Partial System Programming submenu has nine options, where:

Option Description

1=INST Installation – Installation or removal of the Loop Interface Boards from memory.

2=STY Style - Changing (in memory) loops wiring style 6 or 4.

3=TDLY Time Delays - Setting the time delays for Alarm Verification, Bell cutout etc.

4=AVPS Not Used in Australia.

5=ZBND Zone Boundary - Setting the zone boundary for the software memory map.

6=EXTEQ External Equipment - Changing the external equipment options, such as electrical

supervision of the Graphics Monitor.

7=LOCP Local Parameters - Setting local parameters, of Loop devices, and Loop local

mode.

8=ISIB Intelligent Serial Interface Board - Installation or removal of the Intelligent Serial

Interface Board (SIB-2048A or SIB-NET) or Annunciator modules, Also used for

setting ACS port for Upload/Download with Verifire.

9=PARM Additional System Parameters – Selection of additional system parameters such

as the detector day/night sensitivity settings, rapid polling, etc.

0=CONT Continued …….

Subsequent option is 1=IDO, “International Display Option”

Notes

When removing loop interface boards, all installed points on the affected LIBs are automatically

removed upon cycling power to the system. Programming information for installed points can be

stored in a Verifire™ database prior to removal of the LIB. Use of the Verifire™ application for the

reprogramming of previously removed points is highly recommended.

When removing Annunciator modules, all installed points on the affected Annunciators must be

removed first for proper system operation.

Notifier 1010 User Manual

Questions and Answers: