PAGE 70 1010/2020 INSTALLATION AND PROGRAMMING MANUAL
COPYRIGHT © 2000, NOTIFIER INERTIA PTY LTD
Upgrading A Notifier 1010/2020 Version 2.8 to Version 3 AUS 1
1 Upload the config from the FIP to the Laptop using Verifire 2.8 Upload.
NOTE: After the Upload is completed, check & confirm configuration for accuracy.
2 Once the database is checked, open it in Verifire 3. The database will be converted from 2.8
to Version 3.
NOTE: This means the actual database that is opened will be converted. if you wish to be
safe in the event the upgrade needs to be aborted, make a copy of the database before
converting it to 3, so that you can still use the uploaded database with 2.8 Verifire.
3 Replace all the firmware in the entire panel from the 2.8 chips to the V3.0 AUS 1 firmware.
4 Swap the two bottom non-volatile (DSRAM) chips on the CPU Card with each other to
completely erase the systems memory. (CPU card Located top, RHS, front position in back
of FIP)
5 Replace Keypad with New Notifier/Inertia keypad.
6 Power up the Panel.
7 Perform a full System Program. Ensure that all the hardware is installed as it does not
Download through Verifire.
8 Download the new Version 3.0 AUS 1database to the panel.
9 Reset the panel
10 Perform a full test on the system.
To Previous Page
Loading...
Need help?
General
